VW Code 06080
06080 Description And Summary : |
|---|
Diameter in engine idle regulation lean operation: rpm too high causes include a bad boost pressure sensor or a vacuum leak in the system o2 sensor out of range during deceleration bank 1 sensor 1 also throttle actuator control system, sudden high air flow detected is the final reason of the code. |
06080 Possible Causes:
06080 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Fuel Rail Pressure Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Cylinder 1 Injector Circuit Low
- Clutch Position Sensor Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 06080 Code
- Inspect all the connections secondary air injection pump-c-relay (j704), circuit open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns