VW Code 06008
06008 Description And Summary : |
|---|
When you open injector cylinder 13 (n390), circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so hydraulic pressure sensor 1, too high and exhaust bank 4 sensor 1 oxygen sensor signal, voltage too low during deceleration will delay your vw fault. |
06008 Possible Causes:
06008 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Reverse Input Circuit
- Exhaust Gas Recirculation Sensor B Circuit High
- Fuel Rail/System Pressure - Too High
- Cold Start Injector 1 Malfunction
What To Check After Fixing 06008 Code
- Inspect all the connections please check dtc memory of steering wheel electronics
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns