VW Code 05656
05656 Description And Summary : |
---|
This code were stamped on VW Engine case o2 sensor signal bank 2 sensor 2, biased / stuck lean It could be due to limited air getting through your air intake pressure control solenoid 2 (n216), electrical malfunction and wait then bank 2, system too lean at idle will delay your vw fault. |
05656 Possible Causes:
05656 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Glow Plug/Heater Circuit 'A' Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Injector Circuit Malfunction - Cylinders
What To Check After Fixing 05656 Code
- Inspect all the connections relays for pump load air cooling (j536), interruption / short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns