VW Code 05628
05628 Description And Summary : |
|---|
Accumulated in electronic control units so exhaust bank 4, sensor 2, tension too largely It could be due to limited air getting through your air intake angle sensors 1 for butterfly valve drive 2 (g297), signal too largely and wait then load signal, error message from ecu will delay your vw fault. |
05628 Possible Causes:
05628 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 05628 Code
- Inspect all the connections linear oxygen sensor exhaust bank 2 / common ground wire, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns