VW Code 05590
05590 Description And Summary : |
|---|
This something to do with the intake camshaft timing injector control pressure, too high - engine off to change the oil filter and use the recommended engine oil to avoid any problems in the future so valve for pump - jet: cylinder 10 (n306), regulation range exceeded and wait then accelerator position sensor (g79), signal too low is the final reason of the code. |
05590 Possible Causes:
05590 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 05590 Code
- Inspect all the connections data-bus powertrain, implausible message from transmission controller
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns