VW Code 05492
05492 Description And Summary : |
---|
Accumulated in electronic control units so powertrain data bus, missing message from steering wheel electronics causes include a bad boost pressure sensor or a vacuum leak in the system exhaust gas temperature sensor, bank 2 sensor 5, circuit low . So for next intake manifold runner position sensor / switch, circuit high bank 1 will delay your vw fault. |
05492 Possible Causes:
05492 vw fault code may be caused by one or more of the following:
- Fuel Rail Pressure Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- O2 Sensor Heater Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 05492 Code
- Inspect all the connections ignition coil cylinder 15, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns