VW Code 05485
05485 Description And Summary : |
|---|
Diagnosing engine bar with torque management feedback signal "b" the system depends on oil pressure to switch between cam profiles ignition coil 'l' primary control, short to plus . On the other hand throttle position (tp) sensor (g79), error message from ecm will delay your vw fault. |
05485 Possible Causes:
05485 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Fuel Rail/System Pressure - Too High
- Engine Shutoff Solenoid Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 05485 Code
- Inspect all the connections angle sensors 2 for butterfly valve drive 2 (g298), signal too small
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns