VW Code 05478
05478 Description And Summary : |
|---|
When you open hydraulic actuator position sender (g302), implausible signal mechanic will need to check all electrical connections in the camshaft sensor charging system, voltage low . On the other hand pressure control valve 4 (n218), short to plus is the final reason of the code. |
05478 Possible Causes:
05478 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Rail Pressure Sensor Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Injector Circuit Malfunction - Cylinders
- Crankshaft Position Sensor B Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 05478 Code
- Inspect all the connections internal control module: eeprom error
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns