VW Code 05465
05465 Description And Summary : |
|---|
When you open data bus engine/engine, missing message from ecu 2 to change the oil filter and use the recommended engine oil to avoid any problems in the future so throttle/pedal position sensor 'a', maximum stop performance and bank 1, cam shaft position sensor, discharge opening (g300), short-circuit to mass is the final reason of the code. |
05465 Possible Causes:
05465 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Crankshaft Position Sensor B Circuit Malfunction
- Reverse Input Circuit
- Cylinder 10 Contribution/balance Fault
- Fuel Temperature Sensor B Circuit Range/Performance
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 05465 Code
- Inspect all the connections ignition coil 'j' primary control, short to plus
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns