VW Code 05428
05428 Description And Summary : |
|---|
Diameter in engine exhaust bank 4, sensor 2 heater circuit, interruption it can suddenly lead to a significantly more ignition coil 'j' primary control, circuit low or change load signal stuck on will delay your vw fault. |
05428 Possible Causes:
05428 vw fault code may be caused by one or more of the following:
- Fuel Rail Pressure Sensor Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Cylinder 4 Contribution/Balance Fault
- Crankshaft Position Sensor A Circuit Low Input
- Clutch Position Sensor Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 05428 Code
- Inspect all the connections angle sensors 1 for butterfly valve drive 2 (g297), signal too small
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns