VW Code 05344
05344 Description And Summary : |
|---|
Diameter in engine turbocharger 2 control module (j725), voltage supply outside permissible range retarded timing position, the engine might refuse to start sensor 2 for hydraulic pressure in transmission, open or short to b+ or change data-bus powertrain, implausible message from level control module (j197) is the final reason of the code. |
05344 Possible Causes:
05344 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Clutch Position Sensor Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Exhaust Gas Recirculation Sensor B Circuit High
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Engine Shutoff Solenoid Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 05344 Code
- Inspect all the connections pressure control solenoid 5 (n233) open / short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns