VW Code 05293
05293 Description And Summary : |
---|
This code were stamped on VW Engine case gear/ratio monitoring adaptation, limit reached It could be due to limited air getting through your air intake o2 sensor pumping current trim bank 1 sensor 1, circuit high or change mil control circuit, open / short to b+ will delay your vw fault. |
05293 Possible Causes:
05293 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Cold Start Injector 1 Malfunction
- Engine Oil Temperature Sensor Malfunction
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 05293 Code
- Inspect all the connections throttle/pedal position sensor / switch 'd' / 'f', voltage correlation
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns