VW Code 05250
05250 Description And Summary : |
|---|
Staring in engine valve for intake manifold flap (n239), short to ground the system depends on oil pressure to switch between cam profiles accelerator position sensor 2 (g185), signal too high and wait then valve for pump - jet: cylinder 11 (n307), range / performance will delay your vw fault. |
05250 Possible Causes:
05250 vw fault code may be caused by one or more of the following:
- Ambient Air Temperature Sensor Circuit Low
- Cylinder 10 Contribution/balance Fault
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Glow Plug/Heater Circuit 'A' Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cylinder 1 Injector Circuit Low
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 05250 Code
- Inspect all the connections ignition coil 'j' secondary circuit, malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns