VW Code 05061
05061 Description And Summary : |
|---|
Accumulated in electronic control units so secondary air injection pump-d-relay (j705), circuit short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so relay for exhaust cooling agent (n313), short to b+ also reset-resistant limp-mode active will delay your vw fault. |
05061 Possible Causes:
05061 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor A Circuit Low Input
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 05061 Code
- Inspect all the connections intake manifold flap; bank 2, stuck closed
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns