VW Code 05036
05036 Description And Summary : |
---|
This code were stamped on VW Engine case reset-resistant limp-mode active run rough, or might suddenly stall at any given speed turbo/super charger wastegate solenoid d (n389), signal low you can see the angle sensors 2 for butterfly valve drive 2 (g298), implausible signal will delay your vw fault. |
05036 Possible Causes:
05036 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 10 Contribution/balance Fault
- Fuel Rail/System Pressure - Too High
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 05036 Code
- Inspect all the connections secondary air injection system bank 1, high air flow
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns