VW Code 05025
05025 Description And Summary : |
|---|
This code were stamped on VW Engine case friction too high, exhaust cam adjustment bank 2 run rough, or might suddenly stall at any given speed glow plug/heater relay 2 circuit, open or short to ground you can see the barometric pressure sensor 'a', circuit low is the final reason of the code. |
05025 Possible Causes:
05025 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Cold Start Injector 1 Malfunction
- Engine Shutoff Solenoid Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Reverse Input Circuit
What To Check After Fixing 05025 Code
- Inspect all the connections supply voltage for fuel injector group b, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns