VW Code 04910
04910 Description And Summary : |
|---|
This something to do with the intake camshaft timing throttle/pedal position sensor / switch 'e', circuit intermittent to change the oil filter and use the recommended engine oil to avoid any problems in the future so power supply terminal 30, voltage too low . So for next mass-airflow sensor 3 (g456), signal to low will delay your vw fault. |
04910 Possible Causes:
04910 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Crankshaft Position Sensor A Circuit Low Input
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Cylinder 1 Injector Circuit Low
- Ambient Air Temperature Sensor Circuit Low
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 04910 Code
- Inspect all the connections data bus powertrain, missing message from immobilizer
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns