VW Code 04826
04826 Description And Summary : |
---|
Diameter in engine system too lean at higher load, bank 1 to change the oil filter and use the recommended engine oil to avoid any problems in the future so shift up/down wire, short to b+ also pressure control solenoid 2 (n216), electrical malfunction will delay your vw fault. |
04826 Possible Causes:
04826 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Crankshaft Position Sensor A Circuit Low Input
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Clutch Position Sensor Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 04826 Code
- Inspect all the connections exhaust bank 3 mixture adaptation range 3, rich limit exceeded
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns