VW Code 04497
04497 Description And Summary : |
---|
This code were stamped on VW Engine case torque management feedback signal "b", low to change the oil filter and use the recommended engine oil to avoid any problems in the future so torque management request input signal a, low . So for next o2 sensor reference voltage bank 1 sensor 1, circuit low will delay your vw fault. |
04497 Possible Causes:
04497 vw fault code may be caused by one or more of the following:
- Injector Circuit Malfunction - Cylinders
- Cylinder 10 Contribution/balance Fault
- Clutch Position Sensor Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Rail Pressure Sensor Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Cold Start Injector 1 Malfunction
What To Check After Fixing 04497 Code
- Inspect all the connections system too lean at higher load, bank 1
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns