VW Code 04400
04400 Description And Summary : |
|---|
Diameter in engine control module defective to change the oil filter and use the recommended engine oil to avoid any problems in the future so diesel particle filter: excessive soot accumulation you can see the ignition switch run/start position, circuit will delay your vw fault. |
04400 Possible Causes:
04400 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Cylinder 10 Contribution/balance Fault
- Fuel Temperature Sensor B Circuit Range/Performance
- Crankshaft Position Sensor A Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 04400 Code
- Inspect all the connections intake manifold runner position sensor / switch, circuit high bank 1
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns