VW Code 04247
04247 Description And Summary : |
---|
This code were stamped on VW Engine case temperature sensors for drive cycle radiator exhaust (g382), signal too largely to change the oil filter and use the recommended engine oil to avoid any problems in the future so valve 2 for load pressure control (n274), interruption/short-circuit after mass and wait then pressure control solenoid 3 (n217), electrical malfunction will delay your vw fault. |
04247 Possible Causes:
04247 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cylinder 4 Contribution/Balance Fault
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 04247 Code
- Inspect all the connections leak in air intake system
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns