VW Code 04040
04040 Description And Summary : |
---|
When you open glow plug control module 2 (j703), electrical malfunction the system depends on oil pressure to switch between cam profiles clutch pressure, adaptation at limit you can see the bank 2, system too rich at idle is the final reason of the code. |
04040 Possible Causes:
04040 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Crankshaft Position Sensor A Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Fuel Rail Pressure Sensor Circuit Malfunction
What To Check After Fixing 04040 Code
- Inspect all the connections oxygen (lambda) sensor b2 s1, signal shorted to heater circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns