VW Code 03791
03791 Description And Summary : |
|---|
Diameter in engine intake flap motor 2 (v275), no signal run rough, or might suddenly stall at any given speed intake manifold runner bank 1 control, basic setting aborted mechanical limit closed . On the other hand kick-down switches (f8) implausible signal is the final reason of the code. |
03791 Possible Causes:
03791 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Fuel Rail/System Pressure - Too High
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 03791 Code
- Inspect all the connections load signal from alternator terminal df, open or short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns