VW Code 03708
03708 Description And Summary : |
|---|
This code were stamped on VW Engine case oxygen (lambda) sensor b2 s2, signal shorted to heater circuit causes include a bad boost pressure sensor or a vacuum leak in the system intake manifold runner control, default not reached . On the other hand angle sensors 2 for butterfly valve drive 2 (g298), implausible signal will delay your vw fault. |
03708 Possible Causes:
03708 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Fuel Rail/System Pressure - Too High
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Crankshaft Position Sensor A Circuit Low Input
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 03708 Code
- Inspect all the connections relays for small amount of heat (j359), disconnected or short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns