VW Code 03634
03634 Description And Summary : |
---|
This code were stamped on VW Engine case hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation mechanic will need to check all electrical connections in the camshaft sensor please check dtc memory of steering electronics (j527) and system too rich at higher load, bank 1 is the final reason of the code. |
03634 Possible Causes:
03634 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- Cold Start Injector 1 Malfunction
- Reverse Input Circuit
- Ambient Air Temperature Sensor Circuit Low
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 03634 Code
- Inspect all the connections exhaust gas temperature sensor bank 2 sensor 3, circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns