VW Code 03364
03364 Description And Summary : |
|---|
Diameter in engine accelerator position sensor 2 (g185), signal too high to change the oil filter and use the recommended engine oil to avoid any problems in the future so hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation or reductant injection valve bank 2 unit 1, circuit / open will delay your vw fault. |
03364 Possible Causes:
03364 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Cylinder 10 Contribution/balance Fault
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Exhaust Gas Recirculation Sensor B Circuit High
- Fuel Rail Pressure Sensor Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 03364 Code
- Inspect all the connections transmission range display, circuit open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns