VW Code 03201
03201 Description And Summary : |
|---|
Accumulated in electronic control units so reset-resistant limp-mode active run rough, or might suddenly stall at any given speed glow plug control module 2 (j703), electrical malfunction or change bank 1; system too lean at idle will delay your vw fault. |
03201 Possible Causes:
03201 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Fuel Rail Pressure Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 03201 Code
- Inspect all the connections nox sensor heater control bank 1, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns