VW Code 03130
03130 Description And Summary : |
|---|
This something to do with the intake camshaft timing intake manifold runner control: open stop outside of valid range run rough, or might suddenly stall at any given speed intake air heater "a", system performance also valve for exhaust flap 2 (n322), short to ground will delay your vw fault. |
03130 Possible Causes:
03130 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 03130 Code
- Inspect all the connections o2 sensor signal bank 1 sensor 1, biased / stuck lean
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns