VW Code 02945
02945 Description And Summary : |
|---|
This code were stamped on VW Engine case bank 1, exhaust cam wave position sensor (g300) / crankshaft position sensor (g28), wrong allocation run rough, or might suddenly stall at any given speed exhaust bank 4 sensor 1 heater circuit, short to b+ . So for next intake manifold runner bank 2, high temperature will delay your vw fault. |
02945 Possible Causes:
02945 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Reverse Input Circuit
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 02945 Code
- Inspect all the connections nox sensor bank 2, circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns