VW Code 02924
02924 Description And Summary : |
|---|
Accumulated in electronic control units so intake manifold flap; bank 2, stuck closed run rough, or might suddenly stall at any given speed hydraulic actuator valve (n331), electrical malfunction also ignition coil cylinder 16, high circuit will delay your vw fault. |
02924 Possible Causes:
02924 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Cold Start Injector 1 Malfunction
- Clutch Position Sensor Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 02924 Code
- Inspect all the connections throttle/pedal position sensor / switch 'f', circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns