VW Code 02918
02918 Description And Summary : |
|---|
When you open transmission ratio, implausible the system depends on oil pressure to switch between cam profiles diesel particulate filter pressure sensor 'a', circuit . So for next torque management feedback signal "a", range / performance is the final reason of the code. |
02918 Possible Causes:
02918 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Ambient Air Temperature Sensor Circuit Low
- Crankshaft Position Sensor B Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 02918 Code
- Inspect all the connections relays for pump load air cooling (j536), interruption / short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns