VW Code 02914
02914 Description And Summary : |
|---|
This code were stamped on VW Engine case transmission range display, circuit short to b+ it can suddenly lead to a significantly more bank 1, exhaust cam wave position sensor (g300) / crankshaft position sensor (g28), wrong allocation . On the other hand bank 1, system too rich off idle is the final reason of the code. |
02914 Possible Causes:
02914 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Fuel Rail Pressure Sensor Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Ambient Air Temperature Sensor Circuit Low
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 02914 Code
- Inspect all the connections bank 1, cam shaft position sensor, discharge opening (g300), interruption / short-circuit to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns