VW Code 02912
02912 Description And Summary : |
|---|
Accumulated in electronic control units so turbocharger control module 1, missing message It could be due to limited air getting through your air intake ignition coil 'f' primary control, circuit low or control circuit for controller for turbocharger 1 (j724): electrical malfunction will delay your vw fault. |
02912 Possible Causes:
02912 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Cold Start Injector 1 Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Fuel Rail Pressure Sensor Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 02912 Code
- Inspect all the connections intake manifold runner control, lower stop not reached
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns