VW Code 02908
02908 Description And Summary : |
---|
This code were stamped on VW Engine case hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation run rough, or might suddenly stall at any given speed oxygen (lambda) sensor b2 s1, signal shorted to heater circuit and intake manifold tuning (imt) valve position sensor / switch bank 1, circuit intermittent will delay your vw fault. |
02908 Possible Causes:
02908 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Injector Circuit Malfunction - Cylinders
- Fuel Rail/System Pressure - Too High
- Exhaust Gas Recirculation Sensor B Circuit High
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 02908 Code
- Inspect all the connections air cleaner inlet control, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns