VW Code 02860
02860 Description And Summary : |
---|
This code were stamped on VW Engine case transmission output speed sensor 2 (g196), circuit rpm too high mechanic will need to check all electrical connections in the camshaft sensor air cleaner inlet control, circuit low or reset-resistant limp-mode active will delay your vw fault. |
02860 Possible Causes:
02860 vw fault code may be caused by one or more of the following:
- Fuel Composition Sensor Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- O2 Sensor Heater Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Reverse Input Circuit
- Engine Shutoff Solenoid Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 02860 Code
- Inspect all the connections accelerator pedal position sensor 2 (g185), signal too high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns