VW Code 02793
02793 Description And Summary : |
|---|
Diameter in engine evaporative emission system switching valve control, circuit / open to change the oil filter and use the recommended engine oil to avoid any problems in the future so motor for intake manifold flap (v157), short to b+ . On the other hand oxygen (lambda) sensor b1 s3, signal shorted to heater circuit will delay your vw fault. |
02793 Possible Causes:
02793 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Temperature Sensor B Circuit Range/Performance
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Fuel Rail/System Pressure - Too High
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 02793 Code
- Inspect all the connections hydraulic actuator position sender (g302), upper limit exceeded
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns