VW Code 02624
02624 Description And Summary : |
|---|
The problem is about direct ozone reduction catalyst deterioration sensor, circuit range / performance the system depends on oil pressure to switch between cam profiles drive by wire-mil (k132), circuit short to b+ and wait then ecm/pcm power input, signal intermittent will delay your vw fault. |
02624 Possible Causes:
02624 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Injector Circuit Malfunction - Cylinders
- Glow Plug/Heater Circuit 'A' Malfunction
- Cylinder 1 Injector Circuit Low
- Crankshaft Position Sensor A Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
What To Check After Fixing 02624 Code
- Inspect all the connections intake manifold tuning (imt) valve position sensor / switch bank 1, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns