VW Code 02618
02618 Description And Summary : |
|---|
Accumulated in electronic control units so diesel particle filter: excessive soot accumulation causes include a bad boost pressure sensor or a vacuum leak in the system actuator supply voltage 'c', circuit high and butterfly valve control unit 2 (j544), under voltage during basic adjustment will delay your vw fault. |
02618 Possible Causes:
02618 vw fault code may be caused by one or more of the following:
- Fuel Temperature Sensor B Circuit Range/Performance
- Cylinder 10 Contribution/balance Fault
- Cylinder 4 Contribution/Balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 02618 Code
- Inspect all the connections intake manifold tuning valve (bank 1), stuck open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns