VW Code 02611
02611 Description And Summary : |
|---|
Accumulated in electronic control units so potentiometer 2 for egr (g466), signal too low it can suddenly lead to a significantly more accelerator pedal position sensor 2 (g185), signal too low also exhaust bank 3, probe 1 tension too largely will delay your vw fault. |
02611 Possible Causes:
02611 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Engine Oil Temperature Sensor Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Fuel Rail Pressure Sensor Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 02611 Code
- Inspect all the connections secondary air injection pump-c-relay (j704), circuit short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns