VW Code 02526
02526 Description And Summary : |
|---|
Diameter in engine hydraulic actuator position sender (g302), upper limit exceeded It could be due to limited air getting through your air intake accelerator position sensor 1/2 (g79) + (g185), implausible signal and intake air heater "a", system performance will delay your vw fault. |
02526 Possible Causes:
02526 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Shift Solenoid E Performance or Stuck Off
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- O2 Sensor Heater Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 02526 Code
- Inspect all the connections injection pump, fuel calibration not learned
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns