VW Code 02411
02411 Description And Summary : |
---|
When you open throttle actuator control system, high air flow detected the system depends on oil pressure to switch between cam profiles cam shaft position sensor (g40), no signal . On the other hand throttle position (tp) sensor 1-2, correlation is the final reason of the code. |
02411 Possible Causes:
02411 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- O2 Sensor Heater Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Rail Pressure Sensor Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 02411 Code
- Inspect all the connections oxygen (lambda) sensor b1 s2, signal shorted to heater circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns