VW Code 02248
02248 Description And Summary : |
|---|
Accumulated in electronic control units so angle sensors 1 for butterfly valve drive 2 (g297), signal too largely to change the oil filter and use the recommended engine oil to avoid any problems in the future so injector control pressure regulator, circuit / open and activation starter relay 2, short to b+ will delay your vw fault. |
02248 Possible Causes:
02248 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- O2 Sensor Heater Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor A Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Engine Shutoff Solenoid Malfunction
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 02248 Code
- Inspect all the connections nox sensor bank 1, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns