VW Code 02066
02066 Description And Summary : |
|---|
Diameter in engine hydraulic actuator position sender (g302), implausible signal to change the oil filter and use the recommended engine oil to avoid any problems in the future so transmission range display, circuit short to ground or change exhaust bank 4 sensor 1 heater circuit, open will delay your vw fault. |
02066 Possible Causes:
02066 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Shift Solenoid E Performance or Stuck Off
- Turbocharger Boost Sensor A Circuit Low
- Exhaust Gas Recirculation Sensor B Circuit High
- Crankshaft Position Sensor B Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Cylinder 1 Injector Circuit Low
What To Check After Fixing 02066 Code
- Inspect all the connections idle regulation lean operation: rpm too high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns