VW Code 02038
02038 Description And Summary : |
|---|
This code were stamped on VW Engine case a camshaft position actuator control bank 2, circuit high run rough, or might suddenly stall at any given speed starter relay 1, electrical malfunction in circuit (relay stuck / does not switch) you can see the exhaust gas temperature sensor 2 bank 1 (g448) will delay your vw fault. |
02038 Possible Causes:
02038 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Temperature Sensor B Circuit Range/Performance
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 02038 Code
- Inspect all the connections relays for electrical fuel pump 2 (j49), interruption/short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns