VW Code 02009
02009 Description And Summary : |
|---|
This code were stamped on VW Engine case clutch torque, adaptation at limit the system depends on oil pressure to switch between cam profiles reversing light, circuit short to ground you can see the intake manifold tuning (imt) valve position sensor / switch bank 1, circuit low will delay your vw fault. |
02009 Possible Causes:
02009 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Glow Plug/Heater Circuit 'A' Malfunction
- Shift Solenoid E Performance or Stuck Off
- Timing Reference High Resolution Signal A Too Many Pulses
- O2 Sensor Heater Circuit Malfunction
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 02009 Code
- Inspect all the connections 'b' rocker arm actuator control, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns