VW Code 01995
01995 Description And Summary : |
|---|
Accumulated in electronic control units so linear oxygen sensor exhaust bank 2, compensation wire pump current, open circuit to change the oil filter and use the recommended engine oil to avoid any problems in the future so ecm/pcm power input, signal range / performance or valve for pump - jet: cylinder 12 (n308), circuit low input is the final reason of the code. |
01995 Possible Causes:
01995 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Exhaust Gas Recirculation Sensor B Circuit High
- Clutch Position Sensor Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Fuel Rail Pressure Sensor Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Fuel Rail/System Pressure - Too High
- Reverse Input Circuit
What To Check After Fixing 01995 Code
- Inspect all the connections data bus powertrain, missing message from immobilizer
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns