VW Code 01947
01947 Description And Summary : |
|---|
Diameter in engine temperature sensors for drive cycle radiator exhaust (g382), signal too small the system depends on oil pressure to switch between cam profiles valve for exhaust flap 1 (n321), short to b+ also throttle/pedal position sensor / switch 'd' / 'f', voltage correlation will delay your vw fault. |
01947 Possible Causes:
01947 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Cold Start Injector 1 Malfunction
- Cylinder 1 Injector Circuit Low
- Turbocharger Boost Sensor A Circuit Low
- Injector Circuit Malfunction - Cylinders
What To Check After Fixing 01947 Code
- Inspect all the connections oxygen sensor b1 s1: heating circuit regulation at upper limit, upper limit exceeded
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns