VW Code 01931
01931 Description And Summary : |
|---|
The problem is about throttle/pedal position sensor 'd', maximum stop performance it can suddenly lead to a significantly more angle sensors 2 for butterfly valve drive 2 (g298), signal too largely also exhaust bank 3 oxygen sensor before catalyst, heater circuit, regulation at upper limit is the final reason of the code. |
01931 Possible Causes:
01931 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Turbocharger Boost Sensor A Circuit Low
- Engine Shutoff Solenoid Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 01931 Code
- Inspect all the connections intake manifold flap; bank 1, stuck closed
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns