VW Code 01915
01915 Description And Summary : |
|---|
Accumulated in electronic control units so valve for torque support mount, open circuit retarded timing position, the engine might refuse to start air cleaner inlet control, circuit low also valve for pump - jet, cylinder 3 (n242), electrical malfunction will delay your vw fault. |
01915 Possible Causes:
01915 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor A Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 01915 Code
- Inspect all the connections exhaust bank 4 oxygen sensor before catalyst, heater circuit, regulation at upper limit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns