VW Code 01911
01911 Description And Summary : |
|---|
This something to do with the intake camshaft timing angle sensors 1 for butterfly valve drive 2 (g297), signal too small mechanic will need to check all electrical connections in the camshaft sensor drive by wire-mil (k132), circuit short to ground . On the other hand transmission control unit relay, malfunction will delay your vw fault. |
01911 Possible Causes:
01911 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Ambient Air Temperature Sensor Circuit Low
- Fuel Rail/System Pressure - Too High
- Reverse Input Circuit
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 01911 Code
- Inspect all the connections a/c clutch relay, circuit short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns